Standing seam and metal panel roofing, roof repair and full replacement in Murfreesboro. We show up when we say we will, and we clean up before we go.
Everything we do on a roof, done by crews who have been doing it the same careful way since 2002.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Buying, selling, or just want to know how many years you have left? We look, we tell you, and we do not turn it into a pitch for a roof you do not need.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
A skylight has to be woven into the roof, not caulked to it. That is the difference between a fix that lasts a season and one that holds.
An older roof deserves to keep its character. We repair rather than replace wherever the material still allows it.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
A shingle repair should not be visible from the street. We match as close as the weathering allows and blend the new work into the old.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Ice backs up at a cold eave and pushes water sideways under the roof. We clear it without gouging the panels or the shingles.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Standing seam and metal panels have been our specialty since 2002. Around Murfreesboro that means everything from a small porch roof to a full house in dark green, burgundy or bronze, cut and fit on site by crews who have done hundreds of them.
A metal roof done right in Murfreesboro should be quiet inside, straight from the street, and still there long after you have stopped thinking about it. That takes sound decking, real underlayment, and panels that are actually square. We do not skip those parts to save a day.
Why people around Murfreesboro call us back and send their neighbors our way.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Straight answers to what Murfreesboro homeowners ask us most often.
For most Murfreesboro homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Most Murfreesboro houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Sometimes. If the decking is sound and there is only one layer of shingles, a Murfreesboro metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Yes. Gutters, guards, soffit and fascia are all part of keeping the edge of a Murfreesboro roof dry, so we handle them along with the roof instead of sending you off to find somebody else to finish the job.
A typical Murfreesboro shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Most Murfreesboro metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Real feedback from homeowners whose roofs we have worked on.
"They replaced the soffit and fascia the squirrels had chewed through and closed everything back up tight. No more scratching in the attic at night."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"New gutters and guards after they did our roof. No more climbing up there every October to dig out pine needles by hand."
Our crews cover the surrounding area, not only the city limits.